![]() ![]() I removed the screws at the rear of the headliner and replace the screws with screw in snaps, and made the curtain to match the snaps, and added some small bungie cord (actually tent pole elastic) in the hem above the snaps so the curtain would suck up to the ceiling. I use one of those shower curtain rods, and curtains from wall mart with the big holes in them, thread them over the rod, and use some safety pins to fold the curtains in half (too long otherwise) and hold the bottom to the top. I don't have a photo with the curtain in the between cockpit/cabin position, but here it is mounted in the front: In the cold weather, with aircooled heat being precious, I have the curtain in the middle when driving, until I have plenty of heat, and then I can just unsnap it with a little tug. ![]() It also make the cab feel much more roomy with the curtains drawn. That combined with snap in curtains on the side windows replace the bulky factory front curtain that was useless at keeping out the light, and at night with the lights on served more like a one way mirror to look INTO the van. However, the same curtain has additional snaps that match the snaps that I screwed in around the windshield, and it is a nice tight fit against the glass, with the excess rolled up in the angle of the windshield and dash. I now have a snap in curtain that goes there, but is stored when driving, making it less handy. I got the track from a newer model Westfalia, and carefully bent it to match the roof line just forward of the pop top opening, and screwed through it with some really small screws. Really easy to use, and readily available (thus used). It was one piece, and I would slide it behind the drivers seat and tie it back when not in use. I initially installed a track, and made a curtain with a contour to match the roof line. probably less elegant than what you are going for but it worked well. In my bay window I used big magnets and a blanket. ![]() I have a set of light-blocking drapes all ready to go into my '86 Westy but am undecided on their mounting. What are your experiences? Pros and cons? I have seen pictures of what appear to be tracks attached to the headliner with the rear mounting screws and it appears that some have simply rigidly attached said curtains and use tie-backs to keep them open for driving. ![]() Posted: Wed 4:01 pm Post subject: Curtains Behind Front SeatsĪ question for all of those who have installed curtains behind the front seats to add privacy to the rear area - How did you attach them to the headliner or overhead? This page may contain links to eBay where the site receives compensation. The battery is also solar-powered, so if you’re looking for ways to save on energy costs, the My SmartBlinds Automation Kit is an ideal option.Quick sort: Show newest posts on top | Show oldest posts on top These sensors will operate your blinds automatically by monitoring the sun rays as well as your home’s indoor temperature. You can also automate your blinds using the solar monitor and temperature sensors. Users can deviate easily from their schedules by using the manual override option. Use the SmartBlinds app to raise and lower your blinds or set daily and weekly schedules that work with your routines, so you never have to worry about remembering to close your blinds again. Once you install your motors and batteries, you’ll need to download the SmartBlinds app to your phone or tablet. The kit can only be used to retrofit 2- to 2.5-inch corded horizontal blinds, but adding the low-profile motor and battery is such a cinch that it felt silly not to include My SmartBlinds on our list. If you happen to be handy and don’t mind a little DIY, the MySmartBlinds kit might be your best bet. Doing so does require the additional purchase of the Tilt Bridge, but once installed it's convenient to automate your shades with simple raise and lower prompts. If you're using an Amazon Alexa or a Samsung SmartThings smart device, you can also control your Tilt shades with voice commands. If you want on-the-go controls, there are several options. Keep in mind that because the app is powered by Bluetooth and not Wi-Fi, you'll need to operate your motorized blinds while at home. Set schedules, enable sunrise/sunset functions for raising and lowering your blinds, and make adjustments all from your preferred mobile device. The iOS and Android apps connect via Bluetooth. Once installed with compatible windows 23 inches to 74 inches wide, all of your main controls are handled by the Tilt MySmartRollerShades app. The shade motors are powered by solar-charged battery packs, which means no worrying about recharging your power source throughout the year. Available in several colors and material types (including blackout options), the Tilt MySmartRollerShades are an ideal option for those looking to dive into the world of smart shades without the burden of overly-complicated tech. ![]()
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |